Today, chipboard is very often used as facing material for walls. This is quite simple, in addition, such a design does not require preliminary leveling of the walls, only a primer is necessary. Even if your apartment or country house has some irregularities, with the help of the box they will be able to completely close them.
The technology of casing is possible even for those who have never previously encountered construction or finishing work. The first thing you need to do is the box on which chipboard panels will be installed. And if the use of metal profiles was allowed when lining the plastic, Comrade in this case is appropriate exclusively wooden bars. In order to qualitatively hide the wiring into the walls (and in this case it is very easy and simple, and the room will have more than a neat look) metal hoses are used. They are quite flexible, because no one has any problems with their fastening. Subsequently, in the event of a short circuit, fire will not occur, therefore, fire safety can be considered strictly observed.
When installing the box, the beams are located at a distance of at least 40 cm among themselves. In those cases, if you need to hang wall -up sconces, reinforces are made under them. The box is oriented in the corners of the room. The design uses bars with a section of 1.5 by 5 cm, it is best to take antiseptic material for this purpose. After that, the skirting board is laid out, and the chipboard panels are already mounted in its groove.
In order for the latter to not bend and do not give gaps, it is best to install them in the joint. Then these joints are processed with special putty, then the joints themselves must be raged. Self -tapping screws are used as fasteners at this stage, but when installing the box it is necessary to use traffic jams, later they are cut off and the bars are obtained quite smooth. At the end of grinding work, the design is ready.
The design itself almost always comes out cheap enough. The thing is that not one plate from chipboard is used for walls, which in bulk is significantly different, and in order to verify this, go to Companyoo-Eko-Komplekt-820. Add here also the fact that almost the entire Arsenal of DSP will cost you much cheaper than MDF panels and, of course, wooden panels. This is an ideal option for those who need a universal inexpensive design.
