More and more homeowners strive to give all the premises of the apartment or at home as aesthetic appearance as possible and use a variety of methods for this. This attachment also affected the decoration of bathrooms, where many are trying to hide pipes with the help of screens, niches, furniture and installation in the wall. We will tell you more about these methods.
The easiest way to hide the pipes, whether they are plastic or GOST 8639-82 pipes steel or old copper, using hinged and built-in furniture. However, here it must be borne in mind that special requirements should be presented to the selected furniture, which does not always allow you to find what is needed. In this case, you will have to either process the surfaces with special means to protect against moisture, or equip the room with compulsory ventilation and microclimate control. Both of these additional methods are quite expensive, so it is better to use other methods of pipe masking.
The space under the bathroom and pipes can be disguised with the help of screens and false glass that can be bought or made independently from drywall. To do this, we make a frame, the lower part of which is installed on the legs of the bath, and the upper – under the side. To hide the pipes, we make a frame of 4 bars connected in the corners with screws, and attach it to the wall. We make panels from drywall. The smaller panel is equal to the dimensions of the frame, and the large one is 56-60 mm more than its length. Make ventilation holes, connect the panels with screws and fix. You can use mosaic, tiles or protective agents as a decoration of such screens.
Another way is the use of camouflage boxes, including horizontal ones, which are made according to the same principle as the screens, but without a frame. These boxes can be used as a place of storage of bath accessories and accessories, as well as a step before the bathroom.
Vertical plastic pipes in the bathroom can be mounted into the wall. To do this, the walls are made in the wall, while the material of the wall, the thickness of the cladding, etc. are taken into account.D. The stacked pipes are disconnected, shifted with heat -insulating material, plastered, after which the wall is faced.
Finally, let’s say about several rules that must be performed with any chosen method of pipe masking. It is desirable that the pipes are whole or soldered. The existing compounds should be made of the same material, and there should be simple access to them.
